Cement foam concrete wall panel making machine production line Malaysia

Cement foam concrete wall panel making machine production line Malaysia is a kind of foam equipment that allows the foaming agent to reach a certain aqueous solution concentration.

Before starting the foam concrete wall panel making machine Malaysia, the following preparations must be made:

1.After the cement foam concrete wall panel making machine production line arrives at the work site, the installation should be stable. The layout of the conveying pipe should be as short as possible, straight, with few bends and large bends, no air leakage from the pipe joints, fixed vertical pipes, and all pipes should not be stepped on.

2.Check the power supply, motor and electrical control box of the foam concrete machine for light concrete filling for leaks, looseness or short circuits, whether the grounding is intact and whether the insulation performance meets the requirements. Check if the rotation of each motor is correct.

3.Check for lack of oil in the air compressor, lack of oil in the pharmaceutical pump, and lack of gear oil in the reducer. Is there enough oil/lubricating oil for belt conveyors and mixers? Is there water in the gas tank?

4.Check if there is grease on the extrusion tube of the cement foam concrete wall panel making machine production line.

5.Make sure that the wiring is properly connected and that the gas storage tank of the cement foam concrete wall panel making machine production line is free of water.

Prevention:

First of all, the cement foam concrete wall panel making machine production line motor works for a long time and is easy to overheat, causing the motor to burn out. Therefore, pay attention to timely cooling when the foam concrete filling machine runs for a long time. If the motor is found to be overheating, the door of the foam concrete machine can be opened to fill and ventilate naturally. Alternatively, use a fan or blower to cool the motor. Or remove the casing next to the motor to increase heat dissipation capacity. If it is difficult to cool down even after taking these measures, consider stopping the bubbling temporarily.

Second, it minimizes the vibration of foam concrete wall panel making machine Malaysia. This has a devastating effect on the already formed foam production. At the same time, excessive vibration can damage equipment attached to the machine.

Third, when the foam concrete wall panel making machine Malaysia leaks, it is usually caused by the foam inlet pipe or valve. Liquid leaks in foam concrete machines for filling lightweight concrete can cause foam liquid waste and affect foam quality. Therefore, when a liquid leak occurs, it is necessary to stop the machine immediately, inspect it, locate the leaking point, and take immediate measures.

Fourth, if the foam concrete wall panel making machine Malaysia does not work for a long time due to machine failure or other reasons during the construction process, we should pay attention to the problem of removing cement slurry in the mixer and pipeline. A method of processing foam concrete slurry in foam cement pipelines is to use water pumps to connect water pipes to machine pipes. The water pumped by the pump can clean foam concrete slurry in equipment pipelines.

We are a professional manufacturer of foam concrete wall panel making machine Malaysia. Our foam concrete wall panel making machine has been exported to many countries not only because of its cheap price, but also because of its excellent performance.If you have any questions, please feel free to contact us.