Mixing grout with cement

Wode Equipment Co., Ltd. is a leading supplier of mixing grout with cement and other machines in China, as well as a unique supplier with ISO 9001:2008 and CE certificate for the above products in China, our products have been exported to the UAE, USA, Canada, Russia, Malaysia, Pakistan, Korea, Bahrain, Nepal and so on.

Basic maintenance and safety measures for mixing grout with cement:
1. Before starting the mixing grout, check whether the moving parts are jammed by hand, and whether the connections are fastened everywhere, and then the mixing grout can be powered on and idling. Pay attention to whether the equipment has other abnormal phenomena during operation, and pay special attention to the fact that the motor should rotate clockwise when viewed from the connecting shaft of the transmission assembly.
2. When the reversing handle is placed in the vertical downward position, it is the pulping position, and the right side is the pulp discharging position. If the valve body is seriously worn, deformed and rusted (the valve body cannot be transposed due to serious rusting, wipe it with emery cloth and put it in with butter), it should be replaced in time when the sealing is seriously affected.

3. Avoid idle running of the circulating pump for a long time, and prevent large hard particles or easily wound ribbons from entering the circulating pump.
4. Regularly check whether the transmission assembly of the stirring device has serious slurry leakage or the discharged coolant is extremely turbid, and replace the accessories in time according to the degree of wear.
5. Regularly adjust the tightness of the packing seal of the mixing grout with cement for sale. It is advisable to drip a little water from the packing box. Excessive compression will affect the service life of the packing and the efficiency of the equipment.
6. When cleaning the cement mixing grout, the valves at the bottom of the pulping barrel and the bottom of the circulating pump should be opened to fully discharge the residual cement slurry, so as to avoid hardening affecting the equipment efficiency.

Safe use of mixing grout with cement:
1, mixing grout with cement should be set in a flat position, with the wood mat before and after the wheel axle, make the tire put high overhead, so as to avoid moving when starting.
2, mixing grout with cement should implement secondary leakage protection, before going to work after the power is connected, must be carefully checked, the empty try to turn that qualified, can use. During test run, it is necessary to check whether the rotating speed of the mixing drum is appropriate. Generally, the empty speed is 23 revolutions faster than that of the truck (after loading). If there is a large difference, the ratio of the moving wheel to the driving wheel should be adjusted.
3. The rotating direction of the mixing grout with cement should conform to the direction indicated by the arrow. If it is not true, the motor wiring should be corrected.
If you have any needs, please feel free to contact us.