What is a high speed pulper？

High-speed pulping machine is a special pulping equipment developed for low-water-cement ratio grouting materials. It is mainly used in the construction of hydropower, railway, highway, construction, mining and other industries, mixing grouting or grouting agent, cement and water. The slurry can be quickly formed. Compared with the general blade type mixer, it has the characteristics of high pulping efficiency, simple operation, uniform slurry, and short-distance conveying function.

The WM300E and WM400E high-speed pulpers produced by Zhengzhou wode are a high-speed high-shear colloidal slurry mixer. It is designed for use with conventional paddle mixers and pumps, or with its own impeller pump as a separate mixing and placement machine. The unit will quickly and efficiently mix various types of grout, including cement, bentonite and sand. It is specifically designed for cement mixing and grouting in ground/underground works. We can also design mixers and mixers so that mixing can continue.

So what do we need to pay attention to in the later stages of maintenance and maintenance of high-speed pulpers?

First, we cannot stop the injection of cooling water while the equipment is running. The high-speed rotation of the high-speed pulper causes mechanical wear during operation, and the high temperature is instantaneous. If the injection of cooling water is stopped rashly, it is easy to cause internal parts of the vulnerable transmission assembly, resulting in seal failure. In severe cases, the drive shaft is stuck and the motor is burnt.

Second, we must do a good job of cleaning the equipment. After the high-speed pulper is used, the most important follow-up work is to thoroughly clean the residual cement slurry. If the cement is not completely cleaned up, we are very clear and will quickly cake. If a lot of blocks are condensed in the equipment of the high-speed pulper, it will cause equipment failure in the next use. Therefore, the high-speed pulper equipment after use should be filled with butter into the butter hole to improve the inner seal life of the rotating assembly.

About the pulper This article is here, I hope to help you learn more about the pulper.